Page 17 Serial RS Interface RequirementsThe required cable must have a nine-pin “D” type male connectoron one end, which is plugged into the mating serial port locatedon the back of the printer. The printer driver needs to install version 1. PortsPaper sizeSelect the proper size. Answer questions, earn points and help others Answer questions. This equipment generates, us es, and can radiat e radio frequency energy and, if not. Replace with a new print head. Answered on Jan 02,

Uploader: Voshicage
Date Added: 10 February 2014
File Size: 35.61 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 36107
Price: Free* [*Free Regsitration Required]

Trim the front edge of the label backing paper withscissors or a knife. First snap in the left side, andthen the right side.

The simplest way to connect to other hosts not PC compatible orterminals is: Page 26 For NT 4.

Argox Information Co. PrinterDriver200_64-V5.00_101507 Free Driver Download (Official)

General fontsSymbol sets Code pages Note: Hook the white roller onthe brackets of the chassis, ensuring the long thinner endis on the left side. Take off the H. Such proprietary information may not be used, reproduced,or disclosed to any other parties for any other purpose without the expressed writtenpermission of Argox Information Co. Hook the dispenser bar on the brackets of the chassis,positioning it above the white roller.


This unit was tes ted with shielded arrgox on the peripheral devices. Argox OS Thermal Label I hope it helps you. Replacing the Thermal Print Head1.

Argox OS plus User Manual | Page 21 / 41

Argox R Thermal Printer 8 Questions. OrientationSet portrait or landscape. The system assigns the USB port for Label Dr 4 inchmodel printerSetting ParametersAfter installing the driver, follow the path below to set parameters: And the auto calibration function supports 4 modes of setup provides flexibility for the users to choose the most convenient mode for different printing applications to ensure accurate label detection.

Lead the backing paper over the dispenser bar, thenthread dr200 back into the slot between the dispenser bar andH cover, ensuring that it is inserted between the whiteplastic roller and platen roller.

Click back the middle cover. Lift aggox top cover to expose the media compartment. Add the cutter IC baby board to J16 on the main board. Press the “Feed” button for 10 seconds, and the “Ready”indicator and “Power” indicator will go off in order.


To remove any slack, rewind the media onto the roll. RecoveryCaring for Your PrinterAfter using eight rolls of label stock, clean the following areas ofthe printer. Do not connect these pins if you are using ageneral host such as a PC. Posted on Dec 23, Be the first to answer. I am upgrading to a computer with Windows 7. Answered on Jul 05, For Cutting mode you must first install the cutter. Posted on May 15, Be the first to answer.

Argox Printer Drivers and Software | SATO America

This equipment generates, us es, and can radiat e radio frequency energy and, if not. Remove the two screws under the base housing.

Then you should be good to go. Resetting to Factory Default Settings1. If you don’t have drivers and program.

This section does not apply to direct thermal printing. Tell us about it.